- Turn on your TV.
- Press and hold the TV key.
- While holding down the TV key, press the OK key.
- Release both keys. The Device Keys will blink twice.
- Enter the 4-digit TV code you circled. The TV key will blinkthree times.
- To test to see if this was the correct code, point the remote at your TV and press Power. If the TV turns off, you have successfully programmed your remote.
- If the TV does not turn off, repeat all the steps using the next code in the list.
- For future reference, write down the code that worked, in case you must reprogram your remote.
SWITCHING MODES
Press a Device Key at the top of the remote to switch modes. For example,to control your DVD player, press DVD. To return to your FiOS TV Set Top Box (STB), press STB. Pressing the DVD, AUX or TV key is like picking up the remote for that device.
NOTE: When you press Guide,
Widgets, On Demand,
Favorites, FiOS TV or
DVR, the remote assumes you want to control
the STB, and will automatically switch you to STB mode.
CHANNEL KEYS
CH+, CH- and Last control
the STB, even after you press the DVD, AUX or TV Device Key. This is the way most people
will want the remote to work. However,
you can change the way the Channel Keys work, so that when you press a Device
Key, the Channel Keys will operate the selected device.
If you want the Channel Keys to control
different devices…
- Press and hold the STB key.
- While holding down the STB key, press the OK key.
- Release both keys. The Device Keys will blink twice.
- Press 9 - 6 - 6. The STB key will blink twice.
- Press OK. The STB key will blink three times to indicate success in programming.
- Press the UP/DN | LEFT and RIGHT keys to navigate through this menu.
PROGRAMMING THE REMOTE
New remote control comes from the factory
ready to control your FiOS TV service. However, VOL+, VOL- and Mute will
not work until you program the remote with the brand of TV you have. In
addition to your STB and TV, your remote can also control two additional
devices, such as a DVD player and an audio receiver.
To program the remote to control a VCR or
DVD player, press and hold the DVD key, instead of the TV
key. To program an audio receiver,
press and hold AUX instead. You can assign a DVD or VCR to the
DVD key. The AUX key is reserved for audio receivers, amplifiers and VCRs.
NOTE: The remote will exit the programming mode after 20 seconds if
no key is pressed.